Blog 2017-08-11 838 0
Today’s talk is a little problem myself, because before to see many friends about how to get rid of all kinds of labeling the most appropriate on the car, take out so simple to share, in fact also nothing important shortcuts and tricks, don’t call for a man who has a good ability, just share with still struggling with the details of a friend.
It can be very difficult to just dig it out, so it’s not worth it. It’s not worth it. The LOGO and LOGO on the car are glued to the top. If you want it to be easier to dig down, the key is to heat it, and the glue will become soft after heating, which is easy.
This link about heating, hair dryer is a good tool, the effect is no problem, but construction environment will be restricted to vehicles, car parked at ordinary times there are very few of the 220 v power supply (unless they have a separate garage “), so how to use 220 v ac power of blower power supply is a problem. 1: it’s better to have a car inverter (12V direct current to 220V ac), but this is not a universal tool; 2. If your car has no power supply, the length of the wire is also a problem, so we rarely recommend this kind of method which requires too many conditions.
Purpose is to make glue heat, so the process is not important, burn a pot of boiling water to get the car next to the construction should be the lowest cost limits the least way, the effect also can’t bad, of course, if you have better tools and conditions can be trying, in short, make glue thermal softening.
Ps: I will recommend to you the removal of stickers.
Stick glue after soften your car to dig down, it is not much of a problem, if already very flimsy, pick a few times can be down with the hand, if the glue is very strong, still have difficulty with the hand, the other must be careful not to cut your nails, that the loss outweighs the gain, so it is recommended to use some small tools conveniently can find.
There must be CARDS, id CARDS, CARDS, CARDS… All kinds of CARDS, if there are better than these CARDS are thinner CARDS, such as using plate is what to do when you were a child, the car stick side and body forced separation, it is also pretty good method, but due to the card is not too thin, so easy to get off at picking stick or easy to leave a lot of glue in car body, back in to clean up slowly.
If your family some fishing, that would be great, can conveniently take section can help a lot, very fine very strong line can be perfect to remove some sticky stuff, even if is not applicable to hot water, directly with the line separating the car and the body also is very easy, but should pay attention to bring gloves for the best and otherwise hand easily injured, the line also is very sharp.
Sticker to dig down, don’t is all clean, ugly residue glue also have to deal with clean, the shortcut way is to use glue, special tools, but generally and at home in the car also won’t have this thing, if not look at home in the medicine cabinet have wind, also is very good, if really have nothing at hand, remember just mentioned hot water, pour some on a towel, Wu, with her nails a dig it out.
*if you did not receive our reply within 24hrs, please resend to our alternative email: [email protected], or call +86-181.5100.0009 directly.
We will never, ever spam you – nor sell, trade, or transfer your email to anyone else.